收藏本站
OKI-T/3-W32 Series
Adjustable Output 3-Amp DOSA-SMT DC/DC Converters
Speci?cation Notes, Cont.:
(5)
(6)
(7)
(8)
(9)
The On/Off Control Input should use either a switch or an open collector/open drain transistor referenced
to -Input Common. A logic gate may also be used by applying appropriate external voltages which do not
exceed +Vin.
Short circuit shutdown begins when the output voltage degrades approximately 2% from the selected
setting.
For Vout = 1V, Vin must not exceed 32V. For Vout = 0.75V, Vin must not exceed 24V.
Output noise may be further reduced by adding an external ?lter. At zero output current, the output may
contain low frequency components which exceed the ripple speci?cation. The output may be operated
inde?nitely with no load.
All models are fully operational and meet published speci?cations, including “cold start” at –40? C.
(13) Do not exceed maximum power speci?cations when adjusting the output trim.
(14) The maximum output capacitive loads depend on the the Equivalent Series Resistance (ESR) of the external
output capacitor and, to a lesser extent, the distance and series impedance to the load. Larger caps will
reduce output noise but may change the transient response. Newer ceramic caps with very low ESR may
require lower capacitor values to avoid instability. Thoroughly test your capacitors in the application. Please
refer to the Output Capacitive Load Application Note.
(15) Do not allow the input voltage to degrade lower than the input undervoltage shutdown voltage at all times.
Otherwise, you risk having the converter turn off. The undervoltage shutdown is not latching and will
attempt to recover when the input is brought back into normal operating range.
(16) The outputs are not intended to sink appreciable reverse current.
(10) Regulation speci?cations describe the deviation as the line input voltage or output load current is varied
from a nominal midpoint value to either extreme.
(11) Other input or output voltage ranges will be reviewed under scheduled quantity special order.
(12) Maximum PC board temperature is measured with the sensor in the center of the converter.
(17) “Hiccup” overcurrent operation repeatedly attempts to restart the converter with a brief, full-current output.
If the overcurrent condition still exists, the restart current will be removed and then tried again. This short
current pulse prevents overheating and damaging the converter. Once the fault is removed, the converter
immediately recovers normal operation.
www.murata-ps.com/support
MDC_OKI-T/3-W32 Series.A07 Page 4 of 13
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
OKI-T/3-W40P-C CONV DC/DC 3A 15W 24VIN SMD
OKI-T/36W-W40P-C CONV DC/DC 36W 5-15V NEG ON/OFF
OKL-T/3-W12P-C CONV DC/DC 15W 12VIN 3AOUT SMD
OKL-T/3-W5N-C CONV DC/DC 9.9W 3A 5VIN SMD
OKL-T/6-W12N-C CONV DC/DC 30W 6A 12VIN SMD
OKL-T/6-W5N-C CONV DC/DC 19.8W 6A 5VIN SMD
OKR-T/10-W12-C CONV DC/DC 10A 12VIN POL SIP
OKR-T/3-W12-C CONV DC/DC 15W 12VIN SIP
相关代理商/技术参数
OKI-T/3-W32P-C 功能描述:DC/DC转换器 13.5W 0.7525-4.5Vout 3A 9-32Vin Pos Polar RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
OKI-T/3-W40 制造商:MURATA-PS 制造商全称:Murata Power Solutions Inc. 功能描述:Adjustable Output 3-Amp DOSA-SMT DC/DC Converters
OKI-T/3-W40N-C 功能描述:DC/DC转换器 24Vin .75-5.5Vout 3A 15W Neg Polarity SMT RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
OKI-T/3-W40P-C 功能描述:DC/DC转换器 24Vin 0.75-5.5Vout3A 15W Pos Polarity SMT RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸:
OKI-T36W-W40 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Selectable Output 36-Watt DOSA-SMT DC/DC Converters
OKI-T3-W40 制造商:MURATA-PS 制造商全称:Murata Power Solutions Inc. 功能描述:Adjustable Output 3-Amp DOSA-SMT DC/DC Converters
OKI-ZDK-01 功能描述:Zigbee/802.15.4开发工具 ZIGBEE NETWORK DEV BOARD RoHS:否 制造商:Silicon Labs 产品:Development Kits 工具用于评估:EM35x 频率:2.4 GHz 接口类型:USB 工作电源电压:
OKI-ZNED-01 功能描述:Zigbee/802.15.4开发工具 ZIGBEE DEV KIT RoHS:否 制造商:Silicon Labs 产品:Development Kits 工具用于评估:EM35x 频率:2.4 GHz 接口类型:USB 工作电源电压: